HYDRO-STOP® PVC WATERSTOP
PRO-SERIES PROFILES STANDARD PERFORMANCE SPECIFICATION (SPS) GRADE
CORK JOINTING SYSTEMS Hydro-Stop® PVC Waterstops lead the way in high
echnology waterstops and comply with international standards.
Hydro-Stop® PVC Waterstops are extruded from specially compounded PVC
in accordance with BS2782 and they are designed for use in water retaining and water excluding structures where a positive seal is required for poured in-situ concrete expansion, construction and contraction joints.
Hydro-Stop® PVC Waterstops are designed for use in many types of applications and structures, and are available in a number of different size profiles to suit a project’s requirement.
Hydro-Stop® PVC Waterstops are available in rolls with separate intersections supplied to simplify and minimise on-site fabrication. The waterstop is heat weldable and allows for fast and easy on-site welding/joining.
- A full range of profiles and sizes to suit all types of construction requirements
- Hydro-Stop® PVC Waterstops conform to, and exceed all major international standards
- High quality compounded PVC for long term durability and integrity
- Factory made intersections to simplify and minimise on-site fabrication
- On-site welding equipment is available upon request
- Internal profiles come with factory pre-punched eyelets for easy and secure wire tying to reinforcement
- Ability to withstand high hydrostatic head pressures
AREAS OF APPLICATION
Water retaining structures:
- Water tanks
- Water treatment plants
- Sewage treatment plants
- Swimming pools
- Dams and spillways
- Bund walls
Water retaining structures:
- Underground car parks
- Retaining walls
- Suspended slabs
- Below ground slabs
- Roof & podium slabs
PACKAGING: 150mm – 20m = 20m roll, 250mm = 15m roll, | 320mm = 12m roll
ROLL WEIGHT: Dependent upon profile type
STORAGE CONDITIONS & SHELF LIFE: 5 years from the date of production if stored properly in original, unopened and undamaged sealed packaging, in dry conditions out of direct sunlight at temperatures between +10°C and +40°C
MATERIAL TYPE: Polyvinyl Chloride (PVC)
WELDING TEMPERATURES: Approximately 190°C – 200°C
SERVICE TEMPERATURE RANGE: -25°C to +70°C
PROFILE WIDTH SELECTION
On-site joining is a simple exercise using CORK JOINTING SYSTEMS Heat Welding Equipment comprising of an adjustable Welding Jig and Welding Iron. The ends of the waterstop are cut square and placed into the adjustable Welding Jig, then push the ends of the waterstop against the Welding Iron and bring the two ends together until the molten ends of the PVC fuse. When ordering Welding Equipment, please advise profile number of the waterstop required.
FACTORY MADE INTERSECTIONS
HEALTH AND SAFETY INFORMATION
The Company also has no express or implied knowledge of any particular purpose for which the product is required and any such information given will not be taken into account in the supply of this product. No responsibility or liability by the Company will be accepted for misuse, misreading or derivation from recommended guidelines in respect of this product and the user shall determine the suitability of the product for his intended use and assume all risks and liability in connection therewith. The information contained in our brochure may change at any time without notice. Any use of this product, Hydro-Stop® PVC Waterstop, in any application should be approved as suitable for use/application by the Design Engineer and Project Manager.